[ Log In ]
[ Register ]
NEW: CNC Router PLANS Available for all of our Newest CNC Models!! Click here to "Design Your CNC".
.7 x .6 inside dimension cable carrier Inside height dimension of the .7 x .6 inch cable carrier Inside width dimension of the .7 x .6 inch cable carrier
.7 x .6 inside dimension cable carrier Inside height dimension of the .7 x .6 inch cable carrier Inside width dimension of the .7 x .6 inch cable carrier
Price Options Your Cart
Cable Carrier per foot (0.7" x 0.6")
Total Length:

A cable carrier with an inside clearance of 0.7" x 0.6" to organize cables, wires and tubes. Great for smaller machines that have only a few wires and/or tubes along its axis.


The inside diameter of this cable carrier is 0.7 inches (17.78 mm) x 0.6 inches (15.24 mm).

To determine the length of cable carrier you will need for a single axis, measure the axis travel of your machine, divide this by 2 and add 12 inches. The radius of the curl is 2 inches. A cable carrier (or cable chain) is a chain of links that carry your cables, tubes, hoses and conduit so you don't have the possibility of the these cables and other things catching on parts of the machine. The cable carrier runs along the axis and you will need a little more than half of the axis travel length, depending on how your motion and axis is designed.

Purchase compatible brackets separately.

If you find a lower price, let us know.

Related Tutorials
Thumbnail: How to modify the cable carrier.  Removing the pin. Cable Carrier Demonstration and Modification Instructions
We started carrying these new cable carriers that contain yellow hinge pins. The construction of the cable carrier is sturdy, but still has great flexibility. With this sturdiness comes the non-intuitive method of modifying the cable carrier. How is it possible to remove links, or put two cable carriers together? Also, how many wires, cables and tubes fit within the cable carriers.
Two motors moving in opposite directions How To Have Two Motors on a Single Axis Spinning in Opposite Directions on a CNC Machine
In this tutorial we will demonstrate how to have two motors on a single axis spinning in opposite directions with the use of a hex inverter.
Step 8: X-Axis Front and Back
This tutorial is dated, if you are considering a CNC for your personal use, we would highly recommend purchasing a kit that is very stable from our wide range of machines available. We are going to cheat and skip to the x-axis for a minute, well... actually 8 minutes since that's about how long the video is. The CNC router has a table, right? The flat piece that you put the stuff on to cut, right? Well, that piece has this thing called the gantry riding over it. How does that gantry move? It needs to hug this surface and requires a piece underneath. In other words, the gantry cannot move unless this surface is lifted above the ground to accommodate the gantry support and the motor underneath.