This is a 4 pin threaded connector also a replacement for typical spindles used in CNC routers and CNC machines but can be used in many other applications.

This is a 4 pin threaded connector also a replacement for typical spindles used in CNC routers and CNC machines but can be used in many other applications.

This is a 4 pin replacement connector that is found on the back of typical spindles.

This is a 4 pin replacement female spindle connector with a 20mm threaded connection for mechanically securing this connector to the spindle.

Soldering to the tungsten lead of a laser tube can be a frustrating ordeal. Use this post with a screw terminal to make the soldering easier and create a non permanent connection at the same time!

This connector will mate with female connectors that have a 2.54mm pitch (pin spacing) This 2x36 pin header is intended to assist with prototyping. Whether you need to connect or solder, these headers are breakaway: meaning they can be broken apart easily.

This is a 25 pin female end connector for PCB. It functions as a connector for parallel port devices such as stepper motor drivers.

25 pin D-Sub Male connector

25 Conductor Flat Ribbon Cable. This cable is used in conjunction with DB25 male and female connectors in order to create a user-specific cable length. Please specify how much cable you require.

This is a 25 pin D-Sub Female connector

These connectors are perfect for stepper motors and drivers. The female connector is fastened to a panel and can be wired to any device requiring 4 wires. The male connector is connected to the device outside of the electronics enclosure that needs to be connected to the female connector.

This connector mates with this male connector. These connectors are perfect for stepper motors and drivers. This connector would be fastened to a panel. The female connector can also be fastened to the male connectoras they both have mating threads. A set consisting of a male and female connector is also available.

This connector mates with this male panel connector. These connectors are perfect for stepper motors and drivers.

This connector mates with this female connector. These connectors are perfect for stepper motors and drivers. The motor would have this connector on the end of the motor cable and the female mating connector would be fastened to a panel (bulkhead). The male connector can also be fastened to the female connector as they both have mating threads. A set consisting of a male and female connector is also available.

This connector mates with this male connector. These connectors are perfect for stepper motors and drivers.

This is a 4 pin male ribbon cable connector. We use this connector for the Emergency Stop (E-Stop) connector on the Pokeys57CNC controller.

This connector will mate with male headers that have a 2.54mm pitch (pin spacing). This assembly includes three (3) crimp pins and the three position housing. The housing has a flap that keeps the crimp pin from sliding out. The crimp pins can be crimped with a special crimper, or a standard pair of needle nose pliers. This connector works well with our unshielded three (3) conductor cable.

We use this connector with our 2.5 amp stepping motor driver that is used to drive 3D Printers. Our standard 4 conductor cable is perfect for this connector. The crimp pins can be used with wire sizes between 18-24 gauge (AWG). The pitch (spacing between pins) is 3.96mm or .155 inches.